BWT-94 Watch Repair Tool Quartz Movement Tester Measuring Battery Electronics Detector | Инструменты

---

BWT-94 Watch Repair Tool Quartz Movement Tester Measuring Battery Electronics Movement Detector

 

First, the watch tester function: suitable for testing analog signal quartz watch   Its practical feature is to help you test before opening the watch cover, whether it is to stop moving, but actually need to change the battery analog signal quartz watch, or a core that is hindered by the mechanical failure to repair the engine needs to be repaired, instead of changing An indication of a battery;   Please proceed as follows: 1. Make sure the watch does not show any obvious mechanical damage signal; 2. Place the watch in the test area at the center of the instrument, then press the “watch test” button in the upper right corner to start the instrument; 3. If the instrument receives an electronic pulse signal, the green light on the instrument will be rhythmically lit, accompanied by a sound signal;  If it is an old watch, the signal will be once every second.  If it is a new table, the signal is almost once a minute;  If the tester responds to the pulse, the battery has no problem, but a mechanical failure, then it needs professional repair; 4. If the tester does not sound, or no light is on, the watch may be completely broken and needs to be replaced; 5. In order to maintain battery power, the tester will automatically shut down after 2 minutes without manual shutdown;   This tester is also useful for not starting the watch after replacing the battery. If the tester does not respond after pressing the "watch test" button, it may not be in good contact. Take it out and reinsert the battery or turn it slightly;   If the movement emits a pulse and the watch pointer does not move, the watch must be repaired;  Second, the battery test function   1. Select the type of battery (1.55v for silver oxide or 3.0v for lithium battery), the same position for 1.55v   Alkaline button battery is suitable for use; 2. Place the positive electrode of the battery down in the test area and press the contact spring to contact the battery negative. 3. The pointer of the meter should be in the green area; 4. If the pointer cannot point to the green area and the battery is low, it should be replaced;   Important: The battery or tester contact points are not clean, which may result in inaccurate test results;    Basic Information: 1. The functions of the battery and the watch tester are independent of each other and can be performed simultaneously; 2. Unlike the watch test function circuit, the battery test function does not require an internal circuit; it can be inside the tester.   CR2430 can also be used after it has been used up; 3. In order to avoid incorrect watch test results, keep away from or close nearby magnetic equipment, such as monitors, electronic engines, etc.;   Maintenance and battery replacement; Renata BWT94 WATCH & BATTERY TESTER does not require special care. The meter display area and battery test point should be kept clean. It can be cleaned with alcohol and soft cloth to avoid other solutions with solubility properties.   If the watch tester does not work, the battery inside it may need to be replaced; 1. Gently open the battery back cover of the tester; 2. Tilt out the old battery inside; 3. Insert the new RENATA CR2430 battery, 4. Cover the battery back cover, Battery life: 2-4 years, depending on the frequency of use of the tester;