Freeshipping Z&W100DF - Low Flow Control Zone Kit with 1 in. Valve and Filter (Assembled) | Дом и сад

---

Please note that we are selling factory direct products. All our products are 100% brand new in manufacturer's packaging.

valves are designed for a wide range of applications such as municipal turf areas

Product Specifications Flow rate: 0.05 to 9.085 m3/h Pressure: 1.0 to 10.4 bar Temperature: Maximum 52 degrees   Electrical Specifications Solenoid: 24 VAC - 50 Hz/60Hz Surge current: 0.41 A (9.9 VA) Stay current: 0.23 A (5.5 VA) 100D Height: 18.4 cm Length: 14.0 cm Width: 8.3 cm 100D : 1" ((26/34) BSP    Product Model：R25S   Product Category：Filter Item No. R25S Screen Filter   3/4" male thread   Working pressure: 1.0-8.0kg   Flux: 5m³/h   Material: high-strength plastic   We supply 3/4", 1", 1.5" and 2" male thread filter   There are two types of filter core available, stanless steel screen core and dis core   High quality, perfect performance   They apply to the filter system in greenhouse, agriculture and garden irrigation   Easy to clean          

 

 

 

 

INSTALLATION & OPERATING INSTRUCTIONS 1. Flush main line thoroughly before installing valves. 2. Install valve onto main line. Ensure inlet side is connected to main line and outlet side is connected to lateral line. Note arrow on valve indicating direction of water flow. Solenoid should be on the downstream side of the valve. 3. NOTE: Valve is configured for globe installation. For angle installation, remove inlet plug then thread into globe inlet. We recommend using a closed end wrench to avoid strip- ping any molded parts. 4. Use two wraps “Teflon Tape” along the full length of the inlet and outlet pipe threads.Do not use pipe thread or pipe dope compound. Thread inlet pipe and fitting into the inlet port of the valve and hand tighten. Thread outlet pipe and fitting into the outlet port of the valve and hand tighten. 5. Connect one solenoid wire to the controller common wire and the other to the controller power wire. Use only water- tight wire connectors 6. After installing valves, slowly open water supply at point of connection. Valves may discharge water momentarily, then shut off. 7. To activate the valve using the internal manual bleed feature, turn the solenoid handle counter clockwise1⁄4 to 3⁄4 turn or until you hear water flowing through the valve. To close valve, turn the solenoid handle clockwise 1⁄4 to 3⁄4 turn and wait a moment for the valve to close. Only hand tighten the solenoid to close the valve. 8. For automatic valve operation, turn on the controller that has been wired to the valve according to the controller oper- ating instructions, as controllers operate differently. 9. Use the flow control handle to adjust the amount of water flowing through the valve. Counter clockwise turns increase flow; clockwise turns decrease flow. Close the valve before making large flow adjustments, then activate the valve to fine tune flow adjustments. Good adjustment practice, when not intentionally trying to limit the flow, is to turn the flow control stem (from the full up position) clockwise until resistance is felt on the flow control stem hand