DIY small manual bending machine Folding metal iron aluminum copper plate | Инструменты

DIY small manual bending machine Folding machine metal iron aluminum copper plate bending machine

Maximum width: 110 mm, 110 mm (or 11 cm, 11 cm or 0.11 m), but some size under the condition of interference with the sleeve nut, the maximum width of 100 mm (note:. Remove the socket move hands, tighten the plus, extra 10 mm)
Maximum thickness: 0 ~ 2 mm The narrow point 2.5 mm or 3 mm is no problem (note: if it is 3 mm, changes to the machine, increase the clearance only)..
Applicable materials: iron, copper, aluminum, stainless steel, etc.
Minimum flanging height: 8 mm.Thin material, can be smaller to 5 mm.
Gross weight: 2.3 kg
Bending Angle: 90 ° (cant have considered rebound Angle, pressure plate for, namely for small rebound Angle, actual folding to 85 degrees)
(Note: the rebound Angle, it is to point to different materials, or the same material and different thickness, bend, bounce back Angle, any material rebound Angle)
The forming ability:
Depends on the size of the clamp, clamp on 25 mm wide, 8 mm thick.

Note: the default maximum bending machine clearance is 2.5 mm (2.5 mm thick plate to accommodate), minimum 0 mm The need to tighten the clamping nut, after a gap down or plywood will move straight yao maximum clearance.The purpose of not so. narrow bending radius.
(0.5 mm thick stainless steel plate, and the width of 100 mm, inside bend radius around 0.5 mm, outside the bending radius of 1 mm or so)