Мини 19key RF беспроводной RGB пульт дистанционного управления полоса контроллер 12A

Мини 19key RF беспроводной RGB пульт дистанционного управления полоса контроллер 12A

Features:

1) Long distance APP remote control via WIFI;

2) Support routing mode (AP) and LAN connection mode (STA);

3) Support almost every kind of one-wire or two-wire LED driver IC;

4) Brightness adjustable, with 180 kinds of patterns and 8 kind of color adjustable patterns;

5) Creatively using from-image-to-effect method for user to DIY any effect;

6) Support setting pixel number and segments number, able to control up to 2048 pixels;

7) DC5V~24V wide range working voltage, preventing reverse connection of power supply;

8) User setting saving;

AP (Access Point) mode:

Controller and Phone connect directly, controller works as an access point.

Connect steps:

1. When the device is not connected to any WIFI network, power on the controller and wait for 20s and then controller will switch into AP mode;
2. In the WIFI setting page, find and connect the controller (named likeSP108E_xxx, the default pin code is 12345678),
3. Open the LED Shop App, then the controller will be showed on the device lis

STA (Station) mode:

Controller and phone are in one same WIFI network, in this network, users can operate the controller smoothly.

Connect steps:

1. When the device is not connected to any WIFI network, power on the controller, controller will be remain in Wait-For-Connect mode for 20 seconds;
2. Make sure that your phone is connected to a WIFI network, Open LED Shop APP, pressing the Add Device button, input the WIFI pin code, then press the OK to confirm and wait for the configure processing finish;
3. When controller successfully enter the WIFI network, it will be showed on the device list;
4. User can select the controller and remove it out of the network by pressing the Remove Device button, then the controller will switch into AP mode.